JNX40P Overview
Last updated
Was this helpful?
Last updated
Was this helpful?
70711-M2
JNX40-M2 version
70711-LM
JNX40-LM Wifi module version
1.0
Starting document JNX30-LC
1.1
added I2C-MUX + CSI-2 information
Auvidea can take no responsibility for the accuracy or completeness of any information presented in an exported PDF document as the export feature is developed, managed and maintained by GitBook. Those export mechanisms are subject to change without interaction by Auvidea. Please note that Auvidea includes this version table to identify the document and reference changes.
38545-3
changed to 4 CSI-2 connectors with 2 lanes each moved CSI-2 connectors to the bottom side moved I2C3, CAN and SPI0 to the top
This new JNX40P carrier boards have been designed for the Jetson Orin Nano/NX primarily, but they also support the older generation compute modules. A 5V 8A on-board power converter supports the high-power modes of the Orin modules.
Power
6V - 15V
6V - 15V
NX powering
5V 8A
5V 8A
Display Port
no
no
HDMI
yes
yes
Fan connector
yes
yes
M.2 NVME Key M
yes
yes
Micro SD card
no
no
M.2 Key E
yes
no
M.2 Key B
yes
yes
CAN RX / TX
yes
yes
USB 3
3x USB 3.1
3x USB 3.1
Micro USB
1x, host & device mode
1x, host & device mode
Auto Flashing
yes
yes
USB 2.0 (JST-GH)
1x
1x
Gigabit Ethernet, RJ45
1x
1x
PoE option
yes
yes
CSI-2
4x
4x
UART
2x (J14) 1x (GPIO)
2x
I2C
2x (GPIO)
no
I2S (5V tolerant, unidirectional)
1x (GPIO)
no
SPI (5V tolerant, unidirectional)
2x (GPIO)
no
Overvoltprotection with TVS diode
yes
yes
Unidirectional level shifters
yes
yes
Buttons
yes
yes
Power in converter
yes
no
Expandability:
USB and Ethernet module
IMU module
EEPROM and crypto chip (for SW copy protection) module
PCIe x1 connector module
LM823 WIFI module
2x CSI-2 interfaces module
Micro SD card module
RTC battery module
Over current fuse module
UPS option for graceful power down module
On board MCU for watchdog and remote power cycle (LTE) module
JNX40P-M2
JNX40P-LM
HDMI
standard HDMI connector (2.0)
USB 3.0/3.1
10Gb/s (dependent on compute module)
Physical size
80 x 104.6mm
Mounting holes
4x M3
Temperature range
0 to 70°C (extended temperature range optional)
Humidity
noncondensing
Longevity
Very long as no temperature sensitive components are used (like electrolytic capacitors)
Carrier board logic
< 1 watt
3.3/5V power converter efficiency
> 90%
Power in converter efficiency
>90%
Flexible design and manufacturing
designed and manufactured in Germany
in-house fully automated production line with 3D AOI
special configuration possible with minimum purchase of 25 pcs (display port, M.2, PoE, 48V power in, super cap option, 2 RPi camera module connectors, SPI, I2C, switches, etc.)
design services: you architect your custom carrier board and Auvidea designs and produces it, please ask for a quote.
